When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Quick Connect 20 pin Harness (.110 Connectors) for for Brook Universal Fighting Board Cables
One of our goals is not only to make your modding projects simpler, but also faster, allowing you more time to work on more time intensive tasks
The Brook Universal Fighting Board was the start of easing the learning curve to stick modding to add multiple system compatibility to the current stock ones. The typical connectivity was to take each existing wire and connect them directly to the terminal block, which isn't difficult by any means, but it is time consuming, compared to what this harness will offer (especially for fresh stick mods)
Feature:
This has a 20-pin connector on one side (which connects to a 20-pin on the Brook UFB - basically you plug it in and that's it. No more individual wires going from the terminal block. This is super clean and easy
This branches out to the pushbutton (2 sets of 4 button harnesses) and a 3-pin for control. 5-pin JST connector (works with Sanwa Denshi JLF, Hori Hayabusa and Seimitsu joysticks)
In short, for new mods, this cable will easily save you 15-30 minutes of modding time (to make this cable from scratch), depending on your level of experience
Two Version available
This Listing Include:
1pcs 20-pin Buttons & Joyustick Harness for Brook Universal Fighting Board Cables
